Fluido MATIC Electronic Scale Remover

Effectively fights limescale and limescale throughout the home The Fluid'O Matic Apic scale remover is installed on the general water supply after the meter. By reducing the formation of scale (micro-crystals of limescale encrusting), you protect your entire installation, piping and household appliances. In addition to the energy savings you achieve, you extend the life of your devices… Respects the initial qualities of water, very low power consumption: 4W/H. Easy to install: no intervention on the water network, requires no maintenance. TECHNICAL FEATURES Anti-limescale water treatment: the electronic scale remover emits waves that are transmitted through the piping via the turns. These waves transform calcium carbonate colloids (limestone) into non-encrusting micro-crystals. Reverse polarity simplifies device assembly and optimises water treatment. Three power levels, indicated by light diodes, make it possible to optimize the treatment, depending on the hardness of the water, use the TH Test APIC. Other features: Maximum flow rate: 5000 l/h. · Maximum pipe diameter: 30 mm. Length of red and black wires 60 cm LOCATION CHOICE AND MOUNTING The scale remover is installed after the cold water meter of a room in a horizontal or vertical position. Two fixing tabs are placed on the back of the case. Simply position the housing above the pipe, leaving a gap of about 10 cm between the bottom of the housing and the water pipe (on a straight part of the pipe). Drill two holes, place dowels and fix the device with screws. INSTRUCTIONS FOR USE After connection to the mains 220 volts 50 H

• Anti-limescale
• Fluido MATIC Electronic Scale Remover
• FLUID'O MATIC: Electronic Scaling Remover
• Effectively fights limescale and limescale throughout the home